Tap tempo with paws

Spec

Mounting width 6HP (3U)

Power consumption 12V

Included in the package :

Module

10 pin power ribbon

2x knurlies screws

Inputs:

Key : Learn the tempo pressed (Press 4 times)

Tap : By-pass the key, clock 0-5V (Can accept 0-10V)

Reset : Re-sync the clock on a rising edge 0-5V (Can accept 0-10V)

Gate : Determine the time clocks are up from 0% to 100% on the duty cycle

Offset :Determine the time offsets clocks are out of phase from 0 to T

Outputs:

Each output is a 3.5 jack delivering 0V or 10V Following the clock and a multiplier coeficent

Clk : Perfectly the same frequency as the BPM tapped

/2 : Frequency divided by 2 (time bitween two steps multiplied by 2)

/4 : Frequency divided by 4 (time bitween two steps multiplied by 4)